If you need to reconstitute an old system or prepare a new lube system for use, the EPT High Velocity Flushing Service will purify your system and eliminate the need to replace your oil after the flush and keep your project on schedule. 

 For immediate support or quote, please contact Sean Dufresne at (001)-403-519-1310

Service Offerings

• High velocity oil flushing and purification for new equipment installations
• Online lubricant filtration and recovery
• Lubricant removal and reclamation for retiring equipment.
• Centralized drum reprocessing and drum exchange services

Filtration Capabilities

• High velocity particulate removal
• Water removal using vacuum dehydration
• Acid and dissolved contaminant removal using EPT Ion Charge Bonding

On site Oil Analysis Services

• Particle count ISO 4406-09
• Water content by Karl Fisher ASTM D6304
• Acid Number ASTM D974

Lubricant Types

• Mineral Oils, Polyol ester, Phosphate ester, Heat Transfer fluids

Unique Service Offering

• Job completion times are greatly accelerated by supplementing flushing procedures with additional filtration. This additional filtration is often included in both the high velocity loop and as an additional low velocity kidney loop where the fluid is heated, de watered, degasified, and polished. This additional step ensures that the high velocity flush is completed with clean lubricants.
• Real time oil analysis is able to pinpoint progress for the construction or commissioning supervisor. Real time oil analysis is also able to pinpoint filtration loops that require additional attention. This allows corrective action to be immediately taken.
• EPT flushes can be completed with the operating lubricant rather than a separate flushing lubricant and or chemicals. Using the operating fluid ensures there is no secondary lubricant or chemical contamination. Upon completion, fluid particle count will meet or exceed specification. This eliminates the need to replace the lubricant resulting in significant savings. Job completion specifications are verified onsite and by independent lab analysis.
• All EPT equipment used in a service project is flushed with the same type of lubricant required for the flush eliminating the possibility of cross contamination.

HT-10 Flushing oil analysis for the 3” lube oil supply lines.
General Electric LM 2500, Flush duration 7 days

Duke Energy Fall 2003 – From ISO 24/23/21 to 13/11/8